Zeige Artikel getaggt mit Troubleshooting
To receive a successful print, the Z-high has to be perfectly set. For that, you have to adjust the screw of the on/off the motor.
PLA or ABS sticked in the nozzle.
Sometimes, when you are gonna print your model in your printer 3D Touch, while extruder is purging the material, this is sticked in the nozzle. This usually happen with PLA models, when you are purging the extruder, the PLA come c...
Mistake in multi materials models
This mistake only happens if you don't have your <Date, Time and Regional options> of your pc correctly set up for your software Axon 2 V 2.0.1. The problem is that when you are going to print your model, You only can to print the model that you have loaded in your "Material A STL file", the fi...
The models aren’t completely closed.
In little models, sometimes can to be that they aren't completely closed. This could be because the printer doesn’t have place for print the fill of the model. So, if you are gonna print some model, and you have this problem, check in Axon 2 the menu “Build” and then the option “Advanced Settings”, inside of...
The nozzle wipe of the rubbish should be set a few mm over the height of the nozzle. A lot of people think that if the nozzle wipe is touching the nozzle could break it, but don't worry about it, because there is piece of plastic that is flexible and doesn't break the nozzle.
If you set the nozzle wipe under the nozzle, the rest...